OPENAVC ACADEMY / DRIVERS
Practice equipment
Use these controls to change your equipment independently of OpenAVC, then read its state through your driver.
Return to courseOpen your local equipment
Use the temporary fixture credentials created when this prototype started.
Continue from your course
Open your practice equipment through Academy to continue with your saved settings.
Open practice equipmentYOUR CONNECTION
TA-2
Local prototype: TCP, TLS off. Production will use verified TLS. Use the same device password you entered here.
Replace device password
This disconnects both drivers. Update their connection settings with the new password. Equipment state and course progress stay saved.
Replace your equipment password now?
TA-2 / TWO-CHANNEL AMPLIFIER
Equipment controls
DIAGNOSTICS
Test a failure
Suppress replies to keep the connection open while the device stops returning data. Restore replies, reconnect and read current state.
TD-1 / TRAINING DISPLAY
Display controls
Read power and input from OpenAVC to observe an external change.
Test a status reply
Apply a fault to one reply on the selected connection, then send a read command from your driver. An ACK does not consume the fault.
No display connection
Reset display
Restore standby and HDMI 1, clear display faults and close its connections. The amplifier, saved files and course progress are unchanged.
Reset this display now?
PROTOCOL TRAFFIC
Commands and reports
TX: controller to equipment. RX: equipment to controller. Local entries show controls used on this page. Login credentials are excluded.
Connect your driver to see its traffic here.
Reset equipment
Restore both channels to unmuted, −30 dB and no input signal. This closes driver connections and clears faults. Your OpenAVC files and course progress are unchanged.
Reset this amplifier now?